鼎/Kanae
“鼎/Kanae” is one model of 49 kinds of “連鶴/Renzuru”.
Renzuru means connected-cranes which are made of only one paper without glue and tape.
49 kinds of Renzuru was in the book which is “秘伝千羽鶴折形/Hiden-Senbazuru-Orikata”.
The book was published in 1797.
— Total difficulty level —
☆４：☆☆☆☆・・・・・・
— By item —
Tear easily ：☆☆・・・
Complexity ：☆☆・・・
Hard to fold：☆☆・・・
Kanae is the model that three cranes are connected to each other with beaks and tails.
Make only one crane while putting a square on top of another square.
Therefore, make creases neatly!
Completed Kanae
The diagram of Kanae
＜reference＞『Hiden-Senbazuru-Orikata』- was published in 1797
Preparation of an origami paper
【Size】
a 15x15cm paper or it is bigger than 15cm.
【Kinds】
・Basic origami paper
・Double sided origami paper
・Washi paper
I made this model with a 15x15cm basic origami paper.
Since cranes are connected to each other with beaks and tails, this model tear easily.
If you use a double sided origami paper or washi paper, it will get easier to make this model.
Fold the paper in half in each direction.
After making creases, it looks like this picture.
Preparing an origami paper is completed!
Make creases
To make creases on a paper
To make creases on a paper before cutting the paper is very important.
If you cut a paper first before making creases, it will get harder to make creases on the paper.
Also, there’s a possibility that the paper is cut halfway when making creases.
This step is making basic-creases on each square.
On the other page, there is how to make basic-creases.
I will paste the link down below.
Make basic-creases, which are the green lines and the blue lines in this picture, on each square in the paper.
Make basic-creases in each yellow square.
This picture is taken after making basic-creases in each yellow square.
Please make sure whether there are the creases, which are the green lines and the blue lines in the 2 pictures ago, in each yellow square.
Cut the paper
Cut your paper after making creases!
＜reference＞『Hiden-Senbazuru-Orikata』- was published in 1797
Cut the paper while referencing the diagram.
This is an enlarged picture.
I used a 15x15cm paper.
I left about 3mm for the length of the connecting part.
Make sure the direction of each crane
Make sure the direction of each crane
When making Renzuru, to fold cranes while making sure the direction of each crane is very important.
On this site, I will draw lines on each square in a picture.
Make cranes so that the lines are changed to wings.
I recommend that you draw lines lightly on the back in order not to make a mistake.
Make cranes so that the yellow lines are changed to wings.
After making sure the direction of each crane, make the model – Kanae.
In the next pages, there is how to make the model.
If you try to make it by yourself, I recommend that you don’t look at the next page!
